Quick installation by any competent tradesmen
Reduced maintenance cost and down time
Safe and easy with no hot work required
No weld defects. No heat affected zone. No weld spatter. No worries!
The cost of getting pipework repaired due to corrosion, wear, or a simple change in pipework design can be very expensive. With the CRISM fitting it can be installed easily, fast and used for many different applications with our straight, 45 deg, 90 deg and flanged fittings allowing for most modifications to be undertaken.
With our fitting, you can cut the damaged pipe section out, slip on two flanges and then with our fittings and some pipe build a spool to insert straight into the gap created. Not only does our fitting reduce the cost of repair it also significantly reduces the time for a permanent repair.
With the CRISM fitting you do not require the expense of a welder and the associated team to be used on site.
To install the CRISM fitting you do not need to have any qualifications, just follow our simple instructions. Once in place it can be rotated allowing for flange misalignment. The advantage also allows temporary set-ups to trial different flow paths or bypass an Achilles heel in a process situation.
The CRISM fitting can be installed in a very short time. After preparing the pipework a simple slide on and you are ready to start fluids flowing through the pipework.
To check out our CRISM range and for a no obligation customised quote click on the fittings required below. We can source all gasket and bolting requirements to allow for one simple purchase order.
